Need the information of an electrician?

Qusetions: it really is a double box with two switches in it, the grounds are tied collectively, and then the one particular change has two whites, and two blacks. I attempted 3 switches, and several blend of wires (switched the positions in the blacks). one particular change lets me to connect every one of the wires towards the change box, instead than tying the whites collectively, but ends up kicking the breaker anyway. here is what comes about:

Two blacks, very hot about the bottom: change isn't going to do the job, but strength stays on.
Two blacks, very hot on major: change isn't going to do the job, and strength isn't going to get to lights.
Two blacks, and two whites: If I hit the breaker although the change is on, all performs, but when I hit the change, breaker kicks.

What's heading on?

Answers:Wow seems perplexing Just a few concerns although, the number of wires complete do you've, blacks and whites are these single pole switches (light turns on from one particular place) due to the fact it does sound like you might have gotten a four way change consequently a means to hook up all four wires to one particular change or it could be considered a double pole change a change which has on/off on it but is designed for any 220v load a bit additional data could enable us enable you. Hope this Helps

Answers:I had a change the moment which was reversed. once the change "said" off the light was on. As for your two white wires and two black wires often they'll use them for whats referred to as a "switch leg" wherever the strength flows towards the change about the white and back again towards the light about the black or even the other way all-around? attempt checking every single in the four wires individually which has a voltage tester placing one other facet in the tester to ground to discover wherever the strength is. over all be watchful.

Answers:If the change has four terminals it will be considered a four way, making it possible for the light to get managed from three or additional areas? after you get in to those it is usually extremely perplexing when white wires are additional towards the blend. when the breaker blows to possess a neutral wire about the change. you are going to need to have to determine the neutral and obtain a diagram to display the way to wire a four way.

Answers:Not certain what you've, but attempt his. flip off the breaker. connect the two whites wires collectively and connect the two black wires collectively. No change. flip the breaker on. when the light arrives on then, shut the breaker off yet again. disconnect the two black wires. Connect the blacks to every single facet in the change.

Is the change the only one particular that turns the light on, or is there an additional change that turns the similar light on, Just thinking should you had a three way change in advance of and are making an attempt to exchange with an everyday on/off change.